RE: (ASCEND) SOFTWARE UPGRADE KILLS RADIUS AUTHENTICATION???

["Zanten, Marco van" <Marco.Zanten@Alcatel.nl>]

The option stated by Troy looks like a good idee.
e.g. clear config and reload config.

good luck



> -----Original Message-----
> From:	Troy Settle [SMTP:st@i-Plus.net]
> Sent:	dinsdag 5 oktober 1999 15:08
> To:	ascend@digistar.com; Ascend Users
> Subject:	RE: (ASCEND) SOFTWARE UPGRADE KILLS RADIUS
> AUTHENTICATION???
> 
> 
> What is the progress code and disconnect cause reported by syslog
> and/or
> radius?
> 
> Without that (and possibly other information), we're all pretty much
> stuck
> at making wild guesses.
> 
> I assume you checked the obvious stuff like IP pool allocations, ISDN
> configuration, watched radius debugging on the max, etc...
> 
> A possible solution would be to flash to the software you wish to run
> (I'd
> reccomend 7.0.22 at this point) and reboot the max.  When it comes
> back up,
> clear the memory and reconfigure.  Reboot again, and watch to see what
> happens.
> 
> Hope this helps,
> 
> Troy
> 
> 
> > -----Original Message-----
> > From: owner-ascend-users@max.bungi.com
> > [mailto:owner-ascend-users@max.bungi.com]On Behalf Of
> > ascend@digistar.com
> > Sent: Tuesday, October 05, 1999 8:32 AM
> > To: ascend-users@bungi.com
> > Subject: (ASCEND) SOFTWARE UPGRADE KILLS RADIUS AUTHENTICATION???
> >
> >
> >
> > I recently upgraded two MAX 4048s from 6.1.7 to 7.0.0 to 7.0.3 and
> now
> > radius authentication stops working after about 25 users are
> connected.
> >
> > The radius server sends an OK back to the MAX but the MAX reports
> "LAN
> > security error" and drops the caller.  This is bad.  The radius
> logfile
> > shows that user's password was correct and that the login was
> accepted -
> > but the max reports LAN security error and drops the caller anyway.
> >
> > I reloaded 6.1.7 ftik.m40 onto the machines and the problem has
> grown
> > worse.  Instead of about 28 users I now get only about 20 before the
> max
> > starts reporting "LAN security error" and drops callers like flies.
> >
> > What can I do to remedy this problem?  I am losing customers
> already!
> 
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to
> ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>