Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Digital/Analog Dial-up
At 10:40 AM 1/27/98 -0500, Charlie Taylor wrote:
>Perhaps someone on this list can help me.
>
>I would like to support both digital and anolog dial-up users over the
>same set of 4 BRI lines (8-channels) using
>a MAX 1800. I would like to have either a single number that they both
>dial for access or, perhaps, two numbers -
>one for the analog users and one for the digital users.
>
>However, BellSouth tells me I can have a hunt group on voice or data
>but not both. It appears from the documentation for the 1800 that the
>max can route the call to a digital modem or to the bridge/router
>according
>to the dialed number. This indicates to me that I need two hunt groups
>- one for voice and one for data - and that
>I essentially have to allocate (statically) a couple of BRI's for voice
>and a couple for data. This will enevitably
>lead to inefficiencies in the use of the lines.
Check out http://www.ascend.com/890.html for info to give to your telco.
The method you need to use is call forward busy. Beware that this may cost
you some money depending on your tariffs.
With BRI on the telco's 5ESS, you need this special technique to do voice
and data hunting. If you had a PRI, there would be no problem.
Matt Holdrege http://www.ascend.com matt@ascend.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: