Re: (ASCEND) Initial password Pipeline

["Reinier Rijke" <rrijke@encoin.nl>]

Thank you all for helping!

Just for the records, and may be of help for others, the solution which
resulted in a working PL was:

Upload a complete new version of firmware - procedure see below. (we had
6.1.19, now 7.3.0). This erased the password, and partly other settings.
Afer this, we could access the PL on 9600 bd. Reload of the original
firmware wasn't succesfull!

thanks again, succes.

The upload procedure as suggested by Jim Logan:

P50 later models (6xxxxx  722xxxx)  (P75's as well)

With all cables and power removed, open the case and orient the LEDs
toward you (the front).  Locate the large 1.5" square Motorola chip in the
front right corner. At lower left you will need to short JP1.
Attach the power then the serial cable. Configure the terminal software
for 57600 N-8-1 no flow-control You should see a PIPE50> prompt. Type EF
then DF. If EF returns an error, dont worry.  After typing DF upload the
correct version of the software.  The software is about 450K.ont).  When
complete (2-4 minutes) remove the power cord then remove
the jumper. Replace the box lid and power up. Its now running in a factory

original configuration.depending Reconnect the serial cable using 9600
N-8-1 no flowcontrol and configure as desired.




-----Oorspronkelijk bericht-----
Van: owner-ascend-users@max.bungi.com
[mailto:owner-ascend-users@max.bungi.com]namens Reinier Rijke
Verzonden: zondag 22 augustus 1999 18:15
Aan: ascend-users@bungi.com
Onderwerp: (ASCEND) Initial password Pipeline??


This weekend something went completely wrong with my Pipeline 50 (power
failure??0): I cannot access the PL, using terminal. Maybe this is caused by
a general reset, which I applied in order to fix things.

Does someone know how to completely reset the pipeline, and subsequently the
initial password (ascend, secure??)

Thanks for helping, regards,

Reinier Rijke NL



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>