Re: (ASCEND) Problem: MAX-1800, with more than 7 Connections

[Jason Nealis <nealis@babylon.erols.com>]

 I've seen the exact same issue here, Usually a bounce of the box will
cause it to re-sync with the D Channel, I believe this was an issue
in the early 5.0 stream, Have you tried loading 5.0Ap38? 

Jason Nealis
Director Internet Operations
Network Access
Erols Internet
 

On Thu, 8 Jan 1998, Bob Roswell wrote:

> I have two MAX-1800 which both exhibit the same problem
> I have 1 device connected to the serial lan, and 6 devices connected to 
> the BRI's.  Everything is stable.
> If I add a 7th BRI to either unit, the router works for a while, but then 
> the router tells me that another BRI line is unavailable,
> (The status goes from D to a - or sometimes an M or even an X).
> Rebooting or toggling the BRI line  sometimes solves the problem for a 
> few hours.
> I am running  Software +5.0Ap16+.
> Any suggestions
> 
> broswell@syssrc.com
> (410) 771-5544 ext 336
> www.syssrc.com
> 
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi..com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> 

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

References:

• (ASCEND) Problem: MAX-1800, with more than 7 Connections
• From: Bob Roswell <broswell@syssrc.com>

---

• Prev by Date: Re: (ASCEND) SNMP Set to Reboot Max
• Next by Date: (ASCEND) finger for MAX
• Prev by thread: (ASCEND) Problem: MAX-1800, with more than 7 Connections
• Next by thread: Re: (ASCEND) Problem: MAX-1800, with more than 7 Connections
• Index(es):
  • Main
  • Thread