(ASCEND) Very different Ethernet x Wan data(?!)

["Ricardo Freire" <ricardo@allways.com.br>]

Hi,


- MAX6000, 7.0.4
- Linked to a switch at 100Mb full duplex;
- Only analog calls (no ISDN, no OSPF).

Is someone else getting these values for Ethernet interface versus Wan
Ports?


90-300 WAN Stat         | |90-400 Ether Stat     |
>Rx Pkt:  103175787^ | |>Rx Pkt:   50687905 |
 Tx Pkt:      49187951   | | Tx Pkt:          27119  |
    CRC:                  0v    | |    Col:                     0  |


As you can see, the ratio Rx:Tx in the Wan lines is 2:1, while in the
Ethernet is about 2000:1.

When it was 10M half-duplex, the figures in Ethernet had always the same
"size" - TX were even a little bigger than Rx. Wan Stat had the same
behavior: Rx:Tx was always 2:1.

Some clues?

Best Regards,
Ricardo Freire



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>