Re: (ASCEND) PRI Quiescing

[Kevin A Smith <kevin@ascend.com>]

At 10:11 AM 10/15/98 , Greg Martin wrote:
>I have seen this problem on the list but never an answer.
>When quiescing a PRI, I show the channels going to "m"
>but the switch never shows them out of service.  Bell Atlantic
>started a protocol analyzer on my D channel and said I was
>sending "service messages" which was a custom message
>and I should be sending "restart" commands which are
>National ISDN-2 commands.  I have my switch type set to
>NI-2 but the max seems to still send the wrong commands to
>the switch which are then just ignored.  Any suggestions?

We did have a quiesce problem with earlier loads that was fixed in 6.0.9.
(TR#3489)
That may have been a different issue, but just for the record - what
version are you running on the MAX?


Kevin Smith			(kevin@ascend.com)
Ascend Communications...
	...where Network Solutions never end.

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

Follow-Ups:

• Re: (ASCEND) PRI Quiescing
• From: Phillip Vandry <vandry@mlink.net>

References:

• (ASCEND) PRI Quiescing
• From: "Greg Martin" <greg@earth1.net>

---

• Prev by Date: (ASCEND) Second line usage on ISDN
• Next by Date: Re: (ASCEND) ISDN Calls
• Prev by thread: (ASCEND) PRI Quiescing
• Next by thread: Re: (ASCEND) PRI Quiescing
• Index(es):
  • Main
  • Thread