Re: (ASCEND) P.75 works for voice, but not data

[Peter Lalor <plalor@infoasis.com>]

>From: "Peter Copeland" <Tharen@i-t-c.com>
>
>I have a P.75 that works just fine for voice at our Portland site. When you
>plug a phone into either phone port, you can make and receive calls.
>
>I also had tested the router extensively at our St. Paul (MN) office 
>before sending it off to Portland and it had established TCP/IP 
>connections from one St. Paul ISDN line to another P.75 on another 
>ISDN line without a single problem.
>
>Now, this P.75 is in Portland with its new SPIDS and I'm trying to get it
>to communicate over TCP/IP with the exact same St. Paul P.75 router 
>that it successfully communicated with before when it too was in St. 
>Paul, but it isn't working for data. However, it is linked up to the 
>Portland ISDN, since voice works.

Sounds like a telco translations/provisioning problem. After you 
place a call, drop to the terminal and do 'show isdn 1'. What do the 
progress and disconnect code tell you?

If the telco is having a problem placing a clear channel (64k) call 
from your new location, you can have the Pipe place a 56k call by 
changing the setting in the connection profile (do it on the other 
side too). Here in Pac bell land, we place a 64k call by dialing 
1+area code, even for local calls. If that's the case there, just 
dial 7 digits to see if the call goes through 56k. If it does, tell 
telco to fix their problem.
-- 

Peter Lalor           Infoasis
plalor@infoasis.com   http://www.infoasis.com/

"Where's my burrito?" -- Homer
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>