RE: (ASCEND) P.75 works for voice, but not data

["Peter Copeland" <Tharen@i-t-c.com>]

That's not it. It's not a matter of a couple of minutes; the P.75 won't
connect with TCP/IP for even a second. When I PING the St. Paul P.75 from the
Portland P.75, it dials out and immediately disconnects. All this time, the
St. Paul's
P.75 status window shows nothing. 

Again, I can hook a phone into the Portland (and St. Paul) P.75 and dial any 
local or long distance number without problem.


At 09:44 AM 5/2/2000 -0400, you wrote:
>
>
>Try dialing other long distance numbers (any, does not have to be ISDN) and
>from the P75 and monitor the activity in the P75's menu.  If the long
>distance calls sort of hang for a couple of minutes without reaching their
>destination, it is probably a long distance carrier issue.
>
>I had a similar problem when ordering an ISDN circuit for Upper Saddle
>River, NJ.  Bell Atlantic (the local carrier) passed voice long distance
>over to AT&T, but the data long distance was not routing to any long
>distance carrier.
>
>Hope this helps.
>
>
>-----Original Message-----
>From: owner-ascend-users@max.bungi.com
>[mailto:owner-ascend-users@max.bungi.com]On Behalf Of Peter Copeland
>Sent: Monday, May 01, 2000 5:41 PM
>To: ascend-users@max.bungi.com
>Subject: (ASCEND) P.75 works for voice, but not data
>
>
>I have a P.75 that works just fine for voice at our Portland site. When you
>plug a
>phone into either phone port, you can make and receive calls.
>
>I also had tested the router extensively at
>our St. Paul (MN) office before sending it off to Portland and it had
>established TCP/IP connections  from one St. Paul ISDN line to another P.75
>on another ISDN line without a single problem.
>
>Now, this P.75 is in Portland with its new SPIDS and I'm trying to get it
>to communicate
>over TCP/IP with the exact same St. Paul P.75 router that it successfully
>communicated with before when it too was in St. Paul, but it isn't working
>for data. However, it is linked up to the Portland ISDN, since voice works.
>
>Could it be that the local telco in Portland requires "data usage also" to
>be specified when
>ordering BRIs, and whoever ordered the line didn't specify? Switch type is
>still NI-1.
>
>
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>