Re: (ASCEND) ISDN on 24-channel T1

["Jim Jones, Jr." <jimslists@arcomcontrols.com>]

This is interesting...  What do the end users need to take advantage of
this?

ISDN is not available in my area, but 56K ( not v.90 ) would be great!

Jim
----- Original Message -----
From: "Matt Holdrege" <matt@ascend.com>
To: "Dennis Duval" <skipmax@seacove.net>
Cc: <ascend-users@max.bungi.com>
Sent: Monday, October 25, 1999 9:19 PM
Subject: Re: (ASCEND) ISDN on 24-channel T1


> You've always been able to accept ISDN calls on a normal T1. People
> have been doing it for years. The only limitation is that they must
> be rate adapted to 56K rather than the full 64K that you get with PRI.
>
>
> At 04:27 PM 10/25/99 -0500, Dennis Duval wrote:
> >My shop is in an area where T1/PRI is not available, so I have several
> >24-channel T1s.
> >
> >I've been under the impression for a couple of years that I would not be
> >able to deliver ISDN with my maxen though these lines and that I would
have
> >to have BRI and a BRI slot card in order to deliver ISDN.
> >
> >Now I find out that my competitor is delivering ISDN dialup using his PMs
> >over 24 channel T1s.
> >
> >I have one 4048 which does not have the ISDN signaling software
installed,
> >and 3 6096s that do have it installed.  However one phone number rolls
into
> >all of the T1s.  Is it possible to do ISDN with my setup?  If so, what
are
> >the requirements and limitations of doing ISDN without the D-channel
> >signaling?
> >
> >Dennis Duval
> >
> >
> >
> >
> >++ Ascend Users Mailing List ++
> >To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> >To get FAQ'd:   <http://www.nealis.net/ascend/faq>
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>