Re: (ASCEND) ISDN on 24-channel T1

[Matt Holdrege <matt@ascend.com>]

You've always been able to accept ISDN calls on a normal T1. People
have been doing it for years. The only limitation is that they must
be rate adapted to 56K rather than the full 64K that you get with PRI.


At 04:27 PM 10/25/99 -0500, Dennis Duval wrote:
>My shop is in an area where T1/PRI is not available, so I have several
>24-channel T1s.
>
>I've been under the impression for a couple of years that I would not be
>able to deliver ISDN with my maxen though these lines and that I would have
>to have BRI and a BRI slot card in order to deliver ISDN.
>
>Now I find out that my competitor is delivering ISDN dialup using his PMs
>over 24 channel T1s.
>
>I have one 4048 which does not have the ISDN signaling software installed,
>and 3 6096s that do have it installed.  However one phone number rolls into
>all of the T1s.  Is it possible to do ISDN with my setup?  If so, what are
>the requirements and limitations of doing ISDN without the D-channel
>signaling?
>
>Dennis Duval
>
>
>
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:   <http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>