RE: (ASCEND) SOFTWARE UPGRADE KILLS RADIUS AUTHENTICATION???

["Troy Settle" <st@i-Plus.net>]

What is the progress code and disconnect cause reported by syslog and/or
radius?

Without that (and possibly other information), we're all pretty much stuck
at making wild guesses.

I assume you checked the obvious stuff like IP pool allocations, ISDN
configuration, watched radius debugging on the max, etc...

A possible solution would be to flash to the software you wish to run (I'd
reccomend 7.0.22 at this point) and reboot the max.  When it comes back up,
clear the memory and reconfigure.  Reboot again, and watch to see what
happens.

Hope this helps,

Troy


> -----Original Message-----
> From: owner-ascend-users@max.bungi.com
> [mailto:owner-ascend-users@max.bungi.com]On Behalf Of
> ascend@digistar.com
> Sent: Tuesday, October 05, 1999 8:32 AM
> To: ascend-users@bungi.com
> Subject: (ASCEND) SOFTWARE UPGRADE KILLS RADIUS AUTHENTICATION???
>
>
>
> I recently upgraded two MAX 4048s from 6.1.7 to 7.0.0 to 7.0.3 and now
> radius authentication stops working after about 25 users are connected.
>
> The radius server sends an OK back to the MAX but the MAX reports "LAN
> security error" and drops the caller.  This is bad.  The radius logfile
> shows that user's password was correct and that the login was accepted -
> but the max reports LAN security error and drops the caller anyway.
>
> I reloaded 6.1.7 ftik.m40 onto the machines and the problem has grown
> worse.  Instead of about 28 users I now get only about 20 before the max
> starts reporting "LAN security error" and drops callers like flies.
>
> What can I do to remedy this problem?  I am losing customers already!

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>