RE: (ASCEND) NAT & Cisco 2501 IOS 11.1

[Steve LaDuke <steve_laduke@tuttle.com>]

Todd,

Check
Ethernet->Mod Config->Ether options->Proxy Mode=Off

If you turn this *on* incorrectly, the Pipeline does ARP Proxies for
every address in your network.

I tried this.  It wasn't fun.

I hope this helps,

Steve LaDuke
Tuttle & Co.

> -----Original Message-----
> From:	Todd Reynolds [SMTP:todd@ncis.net]
> Sent:	Saturday, January 17, 1998 3:36 PM
> To:	ascend-users@max.bungi.com
> Subject:	(ASCEND) NAT & Cisco 2501 IOS 11.1
> 
> Hi,
> 
> I have a customer connecting from a p130 to a ( on my end ) a p50.  
> They may upgrade to a T1 later that's why the 130.  I'm using a 2501 
> and IOS 11.1.  I haven't set up any routes to the p50.
> 
> When I plug that p50 into my ethernet network within 10 minutes my 
> entire network goes down.  All RIP is turned off.  I had Ascend tech 
> support help me through the NAT config so I "assume" it's correct.
> 
> Any words of wisdom would be helpful.  I have been searching all the 
> archives and Ascends supprot docs on NAT and have not found it very 
> helpful.
> 
> Thank You!
> 
> Todd Reynolds
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to
> ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: (ASCEND) MAx 5.0A static ip problem and routing info.
• Next by Date: Re: (ASCEND) NAT and firewalling
• Prev by thread: (ASCEND) NAT & Cisco 2501 IOS 11.1
• Next by thread: tech support - was (ASCEND) Why TNT?
• Index(es):
  • Main
  • Thread