(ASCEND) Pipeline 220 NAT question

["Sean Howard" <Seanh01@email.msn.com>]

I would like to implement the following configuration on a Pipeline 220:

WAN interface IP:            192.156.50.1            (Registered IP)
Ethernet 1:                        10.0.0.1                     (Private,
nonregistered network)
Ethernet 2:                        209.223.45.1            (Registered
network)

The 10.0.0.0 network is just a bunch of client PC's that only need to surf
the
web and get to internal stuff.   The 209.223.45.0 network consists of
several
web servers.

I only want NAT translation to apply to the 10.0.0.0 network.  I want all
inbound/
outbound traffic for 209.223.45.1 to just go through like a normal router.

As I understand it, you can only have 10 static mappings.  We have several
web servers, each with multiple IP's hosting ~20 web sites, so 10 just isn't
enough.

The Ascend literature I read prior to purchasing the 220 certainly implies
that this is possible, but after going through the config it just seems like
once
you enable NAT routing, it applies to both Ethernet interfaces, and all
networks
attached to them.

Any ideas?






++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>