(ASCEND) Need NAT configs/help for Pipeline 75

[Reid Knuttila <reidk@MR.Net>]

Greetings,

I am attempting to config a Pipeline 75 to do single-address NAT, and have 
been unsuccessful after many attempts. The Pipeline is running system 6.02, 
and I am connecting to a MAX running 5.0Ap36. I followed the directions 
on http://www.ascend.com/895.html

It appears that when I show ip routes, there is no information 
regarding the IP address assigned to my Pipeline from the ISP, nor is 
there any table of information detailing NAT. Routing within the 
192.168.0.0 network works just fine, but there are no routes 
out of the WAN interface. When I turn NAT routing off (fixing the 
ethernet addresses to assigned values) then routing to the WAN is 
fine.

Could someone out there who has NAT currently working on a Pipe75 
(preferably one running 6.02) please send me the results of a 
save-config? It might tell me what I'm missing. Any other hints would be 
helpful as well.

Your help is greatly appreciated.

Regards,

Reid Knuttila
reidk@mr.net
Network Engineer
MRNet



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: (ASCEND) List SNMP objectID for MAX
• Next by Date: Re: (ASCEND) Modem hooked to console port, impossible ?
• Prev by thread: Re: (ASCEND) Max 6.0.0 not clearing correctly sessions down...
• Next by thread: RE: (ASCEND) Need NAT configs/help for Pipeline 75
• Index(es):
  • Main
  • Thread