Re: (ASCEND) Very different Ethernet x Wan data(?!)

[Peter Lalor <plalor@infoasis.com>]

>From: "Ricardo Freire" <ricardo@allways.com.br>
>
>>As you can see, the ratio Rx:Tx in the Wan lines is 2:1, while in the
>>Ethernet is about 2000:1.
>>
>>When it was 10M half-duplex, the figures in Ethernet had always the same
>>"size" - TX were even a little bigger than Rx. Wan Stat had the same
>>behavior: Rx:Tx was always 2:1.
>>
>>Some clues?

Sounds like the Max hears a lot of traffic on the Ethernet that it doesn't
forward out, which might be normal for your network. You could look at the
various "show" stats to see what type of traffic it is, which could be a
clue as to who's doing the talking. Beyond that, it's packet analyzer time.
Or, you could put the Max on it's own port on an Ethernet switch.

Peter Lalor           Infoasis
plalor@infoasis.com   http://www.infoasis.com/
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>