Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) Pipe 75 analog voice features
Dave Tepper wrote:
>
> Until v6.0, the feature buttons were hardcoded to 6,7,8. This mapping is
> done by the phone company. When I replaced by bitsurfr with the P75,
> BellSouth had to reconfigure my ISDN configuration in their software to map
> 6,7,and 8 instead of what the BitSurfr wanted.
>
> If you added an ACO, just find out from Bell Atlantic how they mapped the
> features: conference, transfer, and drop. If you have pre v6.0 software,
> they need to be 6,7 and 8. If you already have v6.0 software, then just
> update your P75 to match BellAtlantic assignments.
>
> The P75 then uses the flash hook to send the switch the appropriate feature
> code. Just remember, all of this only works if you have an "Additional Call
> Appearence" on the B-Channel you are trying to use.
>
Dave, others:
I must really have a mental block here, but I do not understand your
comment, "The P75 then uses the flash hook to send the switch the
appropriate feature code."
Let me back up. I have Centrex with ACO with Bell Atlantic, and they
have set their switch protocols to understand P-75 codes. Furthermore,
I have two P-75s with 6.0 software installed. Now, when I wish to
transfer a call, the normal protocol is to flash-hook, then dial the
number, announce, and hang up. This is essentially the same manner in
which I would perform a transfer on analog Centrex line.
Now, where does the 6, 7 or 8 come in ? Pipeline 6.0 software is set
for button 7 for transfer. But it also has button 6 for conference and
button 8 for call drop. How would I use these features, since a flash
hook is a flash hook, and it does not seem that I am supposed to hit a 6
or a 7 or an 8 on my phone, or am I?
When it comes to transfering a call, and attempting to transfer (and,
say the line is busy, or the party is not in), and then switching back
to the original caller: how should this be handled by the operator of
the analog telephone connected to the pots port of the Pipeline 75? Can
you walk me through that ?
Along these lines, the configuration software has another parameter for
"Hook Activator" and "Double Hook Activator" Can you comment on what
these are used for ?
Thanks in advance!
John
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups: