Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Nokia DX200 Switch with 6.0.0
At 04:06 PM 3/2/98 +0000, Mike Hughes wrote:
>I'm trying out 6.0.0 on my test hardware, and have found this
>problem:
>
>One Max 4000 with 1x K56-16MOD card, connected to an E1 PRI running
>off a Nortel DMS100 switch, appears to be working fine, and has been
>up almost 4 days now.
>
>The line config is:
>Signalling = ISDN
>Switch Type = Net 5
>Framing Mode = 2DS
>(everything else default)
>
>
>The other test box, again Max 400 with 1x K56-16MOD card, but this
>time connected to an E1 PRI fed from a Nokia DX200 switch (and a
>different Telco), will not recieve any calls.
>
>The line config here is:
>Signalling = ISDN
>Switch Type = Net 5
>Framing Mode = G.703
>(everything else default)
>
>In both cases, the line shows as up: L1/TE in status window, and the
>D channel is up.
>
>However, any attempt to call in on the line fed from the Nokia gives
>a network busy tone from the switch.
Perhaps you could post your E1 config to see if you have any of the new 6.0
parameters set incorrectly for Net5 or G.703.
Matt Holdrege http://www.ascend.com matt@ascend.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: