Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ASCEND) Static IP Users

Check the following setting:

    Ethernet -> ModConfig -> Pool only = Yes

If set to 'yes', RADIUS will not assign static IP addresses. Change to 'No'.

Kim W. Premuda
San Diego, CA


Laurent Saehyun Kim wrote:

> Hello all,
>
> I just upgraded our MAXs (4004 and 6000) with 6.1.7.  I reconfigured all
> the settings from scratch.  Since then static IP users does not work.  They
> will connect but can't go beyond MAX.  Is there any setting that allows
> static users in 6.1.7?
>
> Here is the sample RADIUS profile:
>
> user    Password = "UNIX"
>         User-Service-Type = Framed-User,
>         Framed-Protocol = PPP,
>         Framed-Address = XXX.XXX.XXX.XXX          <- Static IP
>         Framed-Netmask = 255.255.255.255,
>         Framed-Routing = None,
>         Framed-Compression = Van-Jacobsen-TCP-IP,
>         Framed-MTU = 1500,
>         Ascend-Maximum-Channels = 1
>
> Note:  The static IP is not allocated from the IP pool used by the MAX.
> This setting worked perfectly before upgrading to 6.1.7 from 6.0.
>
> Thanks,
>
> Laurent
> Laurent S. Kim
> NetroPlex Internet Services
> lshkim@netroplex.com
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:   <http://www.nealis.net/ascend/faq>



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>
Follow-Ups: References: