Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ASCEND) Static IP Users

That is NOT the right answer.  You probably do not
have the Proxy Arp configuration set correctly. 

Ethernet->Mod Config->Ether Options->Proxy Mode = Active

For dial-up configuration Pool Only is normally set to Yes.
Otherwise, you'll end up with clients who can assign addresses
like your mail server or DNS server to their dialup connection.

At 12:06 PM 8/25/98 -0700, you wrote:
>Check the following setting:
>
>    Ethernet -> ModConfig -> Pool only = Yes
>
>If set to 'yes', RADIUS will not assign static IP addresses. Change to 'No'.
>
>Kim W. Premuda
>San Diego, CA
>
>
>Laurent Saehyun Kim wrote:
>
>> Hello all,
>>
>> I just upgraded our MAXs (4004 and 6000) with 6.1.7.  I reconfigured all
>> the settings from scratch.  Since then static IP users does not work.  They
>> will connect but can't go beyond MAX.  Is there any setting that allows
>> static users in 6.1.7?
>>
>> Here is the sample RADIUS profile:
>>
>> user    Password = "UNIX"
>>         User-Service-Type = Framed-User,
>>         Framed-Protocol = PPP,
>>         Framed-Address = XXX.XXX.XXX.XXX          <- Static IP
>>         Framed-Netmask = 255.255.255.255,
>>         Framed-Routing = None,
>>         Framed-Compression = Van-Jacobsen-TCP-IP,
>>         Framed-MTU = 1500,
>>         Ascend-Maximum-Channels = 1
>>
>> Note:  The static IP is not allocated from the IP pool used by the MAX.
>> This setting worked perfectly before upgrading to 6.1.7 from 6.0.
>>
>> Thanks,
>>
>> Laurent
>> Laurent S. Kim
>> NetroPlex Internet Services
>> lshkim@netroplex.com
>> ++ Ascend Users Mailing List ++
>> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> To get FAQ'd:   <http://www.nealis.net/ascend/faq>
>
>
>
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> 
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>
References: