Re: (ASCEND) NFAS on TNT

[Keith Rice <keith@nctimes.com>]

Just a note,
A year or so ago I had an NFAS group through Pac Bell.
It ran great on TAOS 1.3Ap24, but nothing previous to that would work.
When I tried to upgrade into 2.0X, the NFAS groups would not work properly. 
I went a few rounds with Ascend before I go ahold of someone that knew that 
NFAS groups didn't work yet in the 2.0X.  It wasn't until 2.0.9 that it was 
stable!
Since then, I have switched off of that NFAS group (not because of this) 
and cannot tell you of any experiences with the 7.X versions, but my point 
is that NFAS is one of the last things that they used to fix in the code 
because it is not that common, so they say.
Hope this helps
Keith

At 03:10 PM 9/9/99 -0400, you wrote:
>Hi All,
>    when testing the NFAS group that I have set up on our TNT we can
>    Kill the primary D-channel and it switches to the secondary the way
>    it should. However it drops all the calls in the entire group. This
>    isnt normal is it? Telco tells me its my config thats causing the
>    problem. Any Ideas?
>
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:   <http://www.nealis.net/ascend/faq>


Keith Rice
North County Times
Internet Services Manager
http://www.nctimes.net
Phone: (760) 739-6625	
Pager: (888) 996-0289
E-mail Pager: page-keith@nctimes.com
Experience is something you don't get until just after you need it.
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>