Re: (ASCEND) PL 130's

[Jim Howard <jhoward@lyceum.com>]

At 17:58 1999/05/17 -0400, Russell Doyen wrote:
>I have 4 PL130's that are labeled P130-UBRI-FT1.  When I looked at the menu,
>some say they are 56K frame (Nailed 56) and some say they are T1 frame
>(Nailed T1) in the menu's.  BANI (Bell Atlantic Network Integration)  tried

It is possible that someone swaped the daughter cards
after the factory and that somewhere there is a
P130 labeled for 56k but with a T1 card...

>configuring them from BRI use to T1 FR use, and 3 of the 4 started resetting
>in a power up loop.  Does anyone remember the jumpers to clear this?  How
>can I tell by looking, which CSU I have in these boxes?  Could it be they
>were shipped with 56K FR software loads and T1 CSU's?

I had this problem a couple of years ago, 
try powering off, then removing the T1 card,
and powering up again to reconfigure it.

My problem was that I tried to enable FDL,
and if there wasn't an active line connected
that had FDL running the router would continually reboot.

See:
http://www.nexial.com/cgi-bin/ascendbody?h=3&dn=29301&fh

at the Nexial archive, also try to search for
        "T1 problems with Pipeline 130 and 5.1a"

-Jim H
----
Jim Howard             Sr Network Engineer        Lyceum Internet
jhoward@lyceum.com     http://www.lyceum.com/     404.248.1733     

My PGP Public Key: http://www.lyceum.com/~jhoward/pgp-key.txt
Fingerprint: 7E8B E2BA 1314 2535 CB08  CFF9 119B 7CD3 2488 954D

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>