RE: (ASCEND) problems with pipeline

[theorist@mindspring.com]

it works fine at 64K, but not 128K?  as with all NAT issues,
check to see if you can software upgrade into the 6.x.x revisions.
 also, are you sure your ISP is giving you the full 128K support
that you need?  they might be having problems on their end when
you are using the extra bandwith.

Melissa

--- Original Message ---
yoni tzafrir <yonitz@bezeqint.net> Wrote on 
Thu, 13 May 1999 13:13:37 +0200
 ------------------ 
Hi,
i have a pipeline 50, dialing up with NAT (single ip address).
i configured the pipeline to 128K and every few minutes (it is
not
permanent), it stops route. the line are still connected, i am
doing: sh

ip address. i see the address but i can't ping it. i tried both
MP and
MPP. i disable rip and rip2. i have tried to put idle timer=0,
and the
maximum. it doesn't help. meanwhile i configured it to 64k and
it seems
to work well but it's not enough bandwidth.
by the way it dials up to a Cisco access path.
any suggestions?



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>


-----
Sent using MailStart.com ( http://MailStart.Com/welcome.html )
The FREE way to access your mailbox via any web browser, anywhere!

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>