Re: (ASCEND) Multishelf TNT...

["Ashley" <ascendlist@asnet.com.au>]

Apart from the obvious "one set to Master, the other configured as Slave",
Link cables to the right ports, & switches set to different numbere (Neither
being 0 or 7), I've never had any problems getting Multi-shelf to work...
There is no trick.  Post your configs, & we can have a look.
A
----- Original Message -----
From: Todd A. Blank <todd@thenap.com>
To: 'Ascend Users Mailing List' <ascend-users@bungi.com>
Sent: Thursday, 13 May 1999 15:54
Subject: (ASCEND) Multishelf TNT...


> I have not seen much about multishelf TNT configs on this list, so forgive
> me if this has been covered.
>
> I have two TNT shelves running 7.0.4.  One is a Rev P controller (slave),
> and the other is a Rev R controller (master).  I am trying to get them to
> talk without success.
>
> I am using the official Ascend cables, and I have them connected the way
> Ascend says to.  As a matter of fact, I have read all the material on
> Ascend's site regarding Multishelving the TNT.
>
> To anyone out there who has done this:  What am I missing?  It seems like
it
> should be fairly easy.  I have tried all the obvious stuff (rebooting both
> units, etc.)
>
> Thanks in advance to anyone who has any suggestions...
>
> Sincerely,
>
> Todd A. Blank
> Columbus NAP, Inc.
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>