RE: (ASCEND) SNMP Question

[John Coy <jcoy@anc.net>]

That only works on a per-chassis basis on a Max4000/6000.
If a customer dials into multiple chassis with the same
username, shared profiles = no won't help.

Ascend/Lucent should consider putting a feature in the code
that allows chassis to communicate with one another to
determine multiple logins.

John

At 08:54 AM 7/20/99 +0200, Zanten, Marco van wrote:
>Hi,
>
>Why do'nt you set shared profiles = no
>in radius or on the MAX.
>I'm not sure but if it is possible on a 4000 and 6000 but on a TNT it
>can
>
>
>good luck
>
>Marco van Zanten
>
>> -----Original Message-----
>> From:	Sonny [SMTP:sonny@caltel.com]
>> Sent:	maandag 19 juli 1999 17:25
>> To:	ascend-users@bungi.com
>> Subject:	(ASCEND) SNMP Question
>> 
>> Hi all,
>> 
>> Does anybody know what the snmp code is to disconnect a user.
>> I have 4 4000 units and 1 6000 unit.  I am writing script to 
>> check for double logins and then disconnect the abusers that 
>> will run from the crontab.  And yes I have tried reading the
>> mibs and tried a bunch of options, but have been unable to 
>> figure out the right one.
>> Thanks in advance
>> 
>> Sonny Abalos
>> Calaveras Internet
>> ++ Ascend Users Mailing List ++
>> To unsubscribe:	send unsubscribe to
>> ascend-users-request@bungi.com
>> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>