Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) 7.0b6 for Max TNT
The 7.0b6 beta release for the MAX TNT is now available to registered users
on www.ascend.com. The user will see a link to the Beta Agreement Form
from their logon confirmation screen.
The agreement starts at: http://www.ascend.com/private/beta
If the user accepts the agreement they are taken to an index page with all
of the available images.
The 7.0b6 beta release for the MAX TNT contains the following
Features:
MP bonding of analog calls
User-Name options in Access-Accept packets
SNMP-v1 interface changes
Corrections:
* TR 2869 SWAN V.35 cable K pin positive voltage caused loopback.
* TR 3301 The MAX TNT returned incorrect ipRouteProto MIB values of 32 and 33.
* TR 3626 Call routing memory usage improved.
* TR 3866 After changes to a Trap profile, traps were not sent until the
system reset.
* TR 250178 Ascend-First-Destination (189) attribute was not reported in
Stop records.
* TR 1000092 CLID did not work properly on outbound R2 calls.
* FE on DS3-ATM card when the other side of the ATM went down.
* PPP clean up from a terminated call could disconnect a new PPP call.
* Modem card could reset if RADIUS supplied incorrect TCP-Clear port number.
* Changes to Connection TCP-Clear subprofiles.
* FE-1 was occasionally observed when removing multilink PPP channels.
* Accounting records were sent inappropriately when call logging was enabled.
* Show command sometimes did not display two-slot xDSL cards correctly.
* ADSL-CAP cards required port state change for new rates.
* Disabling a port on an xDSL card sometimes did not put the port
Out-Of-Service.
* SNMP fixed for SDSL card.
* Number of LSAs for normal operation of OSPF was too low.
* RIP broadcasts random intervals were too large.
* Frame Relay connection did not come up when T1 channels were not contiguous.
* Connections did not always clear after outbound IP-Fax calls terminated.
Known issues:
* If you replace an older Ethernet card with the new Ethernet-2 card, you
must write new Ethernet profiles for the new card. The old Ethernet
profiles do not carry forward.
* Infrequent, intermittent fatal errors and resets of the Ethernet-2 slot
card have been observed.
* When booting, after the slot cards complete their power-on self tests,
the MAX TNT may continue to not accept calls for a few seconds. Immediately
thereafter, full operation resumes.
* In some configurations, the V.35 Serial WAN slot card can exhibit losses
of connectivity.
* This release is not recommended for use with DM48-v.34 cards under heavy
load.
* Configurable receive and transmit data rate limits are not supported on
the DS3 ATM card. They are supported on the CAP-RADSL, SDSL, and
unchannelized DS3 cards.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups: