Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) use of ip pools in testing
Michael Johnson wrote:
>
> I have the following pools configured on my MAXTNT (2.1.9)
>
> admin> ip-pools
>
> Pool# Base Count InUse
> 1 ###.###.###.128 126 0
> 2 ###.###.###.128 126 0
>
> Number of remaining allocated addresses: 0
>
> I have used several modems to test with before I go production and I have
> noticed the tnt allocated me each ip address in order each time I logged in.
> But, it only went through the first pool and then started over. It didn't
> jump from one pool to the next pool.
>
> In the DEFAULT user on radius, I did not specify which pool to use, because
> I assumed that if I didn't specify it would use both or either. Is there a
> way I can specify multiple pools?
>
> Is this assumption correct? When I have a full load can I expect it to
> properly use the second pool even though it didn't when I was testing?
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
i dont think there is a way to cycle the pools but i know that
when the first pool is full it will use the second.
Assaf Homsky
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: