Re: (ASCEND) filter change for port 9 attack

[Daniel <daniel@lynx.bc.ca>]

I have put on the Filter as you stated in Max4048 without any luck. 
When I run the ascend kill program, my max4048 hangs and the "Fault" light
is blinking. I am running ftik.m40. Below is what I got from the
fatal-history:

Index:1 Load: ftik.m40 Revision 6.0.0 
Location: b00f7dd4 b00f8e10 b0063a3c b00609e0 b0069dd8 b0069e4c

Any suggestion?

Daniel

At 12:23 PM 3/17/98 -0800, you wrote:
>For those who are having problems, try this instead...
>
>	In Filter 01
>		Valid=Yes
>		Type=IP
>		IP...
>			Forward=No
>			Protocol=17
>			Dst Port Cmp=Eql
>			Dst Port #=9
>
>	In Filter 02
>		Valid=Yes
>		Type=GENERIC
>		Generic...
>			Forward=Yes
>
>
>In other words, use generic rather than IP in filter 2.
>
>Matt Holdrege		http://www.ascend.com	matt@ascend.com
>++ Ascend Users Mailing List ++
>To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd:	<http://www.nealis.net/ascend/faq>
>
>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

References:

• (ASCEND) filter change for port 9 attack
• From: Matt Holdrege <matt@ascend.com>

---

• Prev by Date: Re: (ASCEND) PRI Config question
• Next by Date: Re: (ASCEND) Ascend Router SNMP Security Issues [Q]
• Prev by thread: Re: (ASCEND) filter change for port 9 attack
• Next by thread: (ASCEND) Part II-Configuring Your filter(FIXED)
• Index(es):
  • Main
  • Thread