Re: (ASCEND) factory state

[Jim Howard <jhoward@lyceum.com>]

At 13:54 1998/02/28 +0100, Rob Dirksen wrote:
>I seem not to be able to get a p50 5.1A back in its factory state.

>the unit resets and is still in the same config state as before.

I've not seen of any problems with clearing a config 
this way, but I havn't done it too many times either ;^)

the two things that come to mind are to upgrade to a 
newer patch release and try again, or...
short the hardware-debugging jumper and reboot,
clear flash completely and upload new software.
(check the FAQ at the URL below for details on this)

-Jim H
----
Jim Howard             Sr Network Engineer        Lyceum Internet
jhoward@lyceum.com     http://www.lyceum.com/     404.248.1733     

My PGP Public Key: http://www.lyceum.com/~jhoward/pgp-key.txt
Fingerprint: 7E8B E2BA 1314 2535 CB08  CFF9 119B 7CD3 2488 954D

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: Re: (ASCEND) P25 bridge -> P25 router
• Next by Date: Re: (ASCEND) 6.0.0 for the MAX family
• Prev by thread: Re: (ASCEND) factory state
• Next by thread: (ASCEND) 6.0.0 and FE29 *mutter*
• Index(es):
  • Main
  • Thread