Re: (ASCEND) Pipe 130 resets

[Jim Howard <jhoward@lyceum.com>]

At 07:52 1998/07/17 -0400, Tom Gwilt wrote:
>However, if the cable is unplugged from the Wan (T1, not ISDN) port,
>the ethernet and terminal mode works fine.

I have seen this happen for two possible reasons before,

a> polarity (tip/ring) of the line out of the smart jack was backward
        that is for the cable between the jack and the P130
        you might need to build one that looks like this:
                1 -> 2
                2 -> 1
                4 -> 5
                5 -> 4

b> when using FDL on the line
        check to see if you have  Nailed T1->Mod Config->FDL=None

also, try setting Clock Source=No

does the router still die if it boots and then you connect the line?
what software rev?

-Jim H
----
Jim Howard             Sr Network Engineer        Lyceum Internet
jhoward@lyceum.com     http://www.lyceum.com/     404.248.1733     

My PGP Public Key: http://www.lyceum.com/~jhoward/pgp-key.txt
Fingerprint: 7E8B E2BA 1314 2535 CB08  CFF9 119B 7CD3 2488 954D

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

Follow-Ups:

• (ASCEND) TNT: Cause code 185
• From: WCN Customer Service <cust.service@wcc.net>

---

• Prev by Date: (ASCEND) PPTP?
• Next by Date: Re: (ASCEND) Problems on 7.0b0?
• Prev by thread: (ASCEND) Pipe 130 resets
• Next by thread: (ASCEND) TNT: Cause code 185
• Index(es):
  • Main
  • Thread