Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Static IP Users
>Hello all,
>
>I just upgraded our MAXs (4004 and 6000) with 6.1.7. I reconfigured all
>the settings from scratch. Since then static IP users does not work. They
>will connect but can't go beyond MAX. Is there any setting that allows
>static users in 6.1.7?
>
>Here is the sample RADIUS profile:
>
>user Password = "UNIX"
> User-Service-Type = Framed-User,
> Framed-Protocol = PPP,
> Framed-Address = XXX.XXX.XXX.XXX <- Static IP
> Framed-Netmask = 255.255.255.255,
> Framed-Routing = None,
> Framed-Compression = Van-Jacobsen-TCP-IP,
> Framed-MTU = 1500,
> Ascend-Maximum-Channels = 1
>
>Note: The static IP is not allocated from the IP pool used by the MAX.
>This setting worked perfectly before upgrading to 6.1.7 from 6.0.
>
>Thanks,
>
>Laurent
>Laurent S. Kim
>NetroPlex Internet Services
>lshkim@netroplex.com
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>
Well,
I have both Pool-Only = Yes and Proxy Mode = Active and it still does not
work. Here is an interesting thing though.
Our Router Address XXX.XXX.XXX.1
Max4004 XXX.XXX.XXX.10
Max6000 XXX.XXX.XXX.130
If I assign a user with static IP such as XXX.XXX.XXX.1, it works fine
without any problem when dialed to Max4004 or Max6000 (Note that the
static IP is on the same Class C network)
If I assign a user with static IP from another Class C YYY.YYY.YYY.250, it
does not work; however, if I set the static route from the router ( ip
route YYY.YYY.YYY.0 255.255.255.0 XXX.XXX.XXX.10 ) it works but only to
Max4004.
I have RIP turned off on both MAXs.
Any idea?
Laurent S. Kim
NetroPlex Internet Services
lshkim@netroplex.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: