You could try: # cdrecord -v speed=8 dev=0,0,0 driveropts=burnfree cdimage.iso On Fri, 2003-06-06 at 23:06, Shawn wrote: > I'm learning how to burn a cd with cd-record. I'm following this page: > http://www.tldp.org/HOWTO/CD-Writing-HOWTO-3.html#ss3.1 > > However, I'm either forgetting an option, or doing something wrong because it's not mounting after creation on linux box: > > mount: wrong fs type, bad option, bad superblock on /dev/cdrom, > or too many mounted file systems > (could this be the IDE device where you in fact use > ide-scsi so that sr0 or sda or so is needed?) > > It's a Yamaha IDE cd-r/w, and I've got the scsi emulation loaded. Here's the steps that I took: > > # mkisofs -r -o cd_image cdfile/ > > After this was done, I could mount it in a loopback device and see the files desired to be burned: > > # mount -t iso9660 -o ro,loop=/dev/loop0 cd_image /cdrom > > After unmounting, I run cdrecord -scanbus and get the device info: > > scsibus0: > 0,0,0 0) 'YAMAHA ' 'CRW2100E ' '1.0M' Removable CD-ROM > > Then, I create the cd: > > # cdrecord -v speed=8 dev=0,0,0 -data cd_image > > I don't recall seeing any error messages in the creation process. What am I doing wrong? Thanks. > > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org tclug-list at mn-linux.org > https://mailman.real-time.com/mailman/listinfo/tclug-list -- Chris Frederick <cdf123 at cdf123.com> _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list