If you use static IP's, and the new location uses DHCP, you will have to configure your Red (Internet) interface to use DHCP. There have been a few new versions since I've used IPCop, so I can't tell you exactly how to do it. http://ipcop.org probably can though. Mark Courtney > Just wondering if anyone else has tried to set up a firewall on US Cable > (aka Warpdriveonline) access. I've been trying to setup a firewall using > IP Cop on an older P166 for a friend of mine, and have been running into > a few issues. Initially, I had a bad NIC which was replaced. Now, I'm > not getting any external connection. I can ping everything internal, and > it's fine. But I'm getting a "network not found" error message on boot > up. He can connect with his Winders box no problem. His cable modem is a > Terayon TJ615, and I have the settings correct. Or, as best as I can > figure out from their not so informative support site along with grabbing > info from his windows machine when connected. I've placed a call to their > support division yesterday, but have not received a call back yet. Just > wondering if I need to have the MAC address set on their end, or if > there's something else I'm messing up. As an fyi, I did have this machine > setup as my firewall originally with DSL and it worked fine. But I have > static IP's and he gets DHCP from his provider. > > -- > Shawn > > The very powerful and the very stupid have one thing in common. Instead of > altering their views to fit the facts, they alter the facts to fit their > views... which can be very uncomfortable if you happen to be one of the > facts that need altering. --Doctor Who, "Face of Evil" > _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list