I've been working on an install of gentoo for a while, and I've finally got the kernel compiled. When I go to boot, though, I always run into a problem with eth0. It says that it can't bring up eth0. I'm kind of stuck -- I don't really know where to start trying to fix this. It would seem to me that maybe I didn't compile support for my ethernet card, but I don't know what to do there. I've got a linksys lne100tx which doesn't show up in the kernel configuration anywhere. When I ran gentoo install off the cd, it found my card fine and got it working. Could it be something other than the card driver? In /etc/conf.d/net, I set it up to do dhcp. Do I need to do more than that in net.eth0? Anybody have any suggestions? Perhaps this is obvious. Ack. justin _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list