Re: (ASCEND) Framed-Address

["Brian Sullivan" <brian@polnow.net>]

HI ALL,

> Try to enable RIP or OSPF both at MAX and your backbone router...
> When a static IP user connetcs to MAX, Max should advertise this user's
> IP routing to your backbone router. (I assume that user's framed IP is not
> in the
> Max's ethernet IP subnet range. If so there shouldn't be a problem if you
> set
> Ethernet>Mod Config>Ether Options>Proxy Mode=Active...)
> Yasin KAPLAN - INTRAkets
> Teknik Mudur - Technical Manager
> Tel:+90 (216) 3276930 Ext. 116 Fax: +90 (216) 3276924
> http://www.intrakets.com.tr/ kaplan@intrakets.com.tr

This is the odd thing, the Static IP address that I'm assigning IS in the
same IP subnet range as the Max's ethernet...  I do have Proxy
Mode=Active...  The pool of dynamic IP addresses is also in the same subnet
range as the Max's ethernet...  Here's a copy of my Radius record for a
static user:

username    Password="password"
        User-Service = Framed-User,
        Framed-Protocol = PPP,
        Framed-Address = 192.168.0.23,
        Ascend-Assign-IP-Pool = 0,
        Ascend-Idle-Limit = 900,
        Ascend-Data-Filter = "ip in forward tcp est",
        Ascend-Data-Filter = "ip in forward dstip 192.168.0.0/23",
        Ascend-Data-Filter = "ip in drop tcp dstport = 25",
        Ascend-Data-Filter = "ip in forward"

Is the "Ascend-Assign-IP-Pool=0," causing troubles?  Do I need a
"Framed-Netmask" attribute?

Thank all of you for your help...

Brian Sullivan
brian@polnow.net


>
> -----Original Message-----
> From: owner-ascend-users@max.bungi.com
> [mailto:owner-ascend-users@max.bungi.com]On Behalf Of Brian Sullivan
> Sent: Tuesday, September 21, 1999 12:40 AM
> To: ascend-users@bungi.com
> Subject: (ASCEND) Framed-Address
>
>
> I'm trying to give certain dial-in users static IP address assignments.
In
> this case the static IP address assignment is outside of the pool of
> addresses I have assigned to the Ascend 4048.  The user is authenticated
> with no trouble, the IP address is properly assigned, but the user cannot
> get any data across the PPP connection.  If I attempt to ping that
assigned
> IP address I get no data bounced back...
>
> Is there a setting that I need to change to tell the Ascend 4048 to route
IP
> traffic when a static IP address is assigned?
>
> Thanks in advance for any help...
>
> Brian Sullivan
> brian@polnow.net
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>