RE: (ASCEND) PRI does not fill up after reboot

["Eric R. Larsen" <eric@istal.com>]

I have the problem that the PRI lines on my 6048 do not come back up unless 
I do a reset (warm boot) of the machine. If I switch the lines to a 4048 
machine the problem does not occur.

Eric
IST

-----Original Message-----
From:	Phillip Vandry [SMTP:vandry@Mlink.NET]
Sent:	Tuesday, May 11, 1999 11:07 AM
To:	ascend-users@bungi.com
Subject:	(ASCEND) PRI does not fill up after reboot

I've seen the following problem as long as I've had Maxes. I'm wondering
if anyone else has seen it or knows what the cause is.

After a Max reboots, either normally or abnormally, the PRIs come back up,
but they refuse to fill up. After n channels are filled up, the number
rings busy. n may be anywhere from 2 or 3 to 20 or more.

And it's always the same channels. As a fictitious example, I may see
after a reboot that channels 1-5 work, and 10, 15, and 20-23 (for a total
of 10 channels). The rest look idle according to the Max but they can't
receive calls.

If one of the calls on the 10 working channels drops, another call will
come in to replace it, but the remaining channels juts don't get used.

The problem clears after several consecutive reboots (after the reboot that
caused the problem in the first place).

Using NFAS across 2 PRIs, MAx 4048's, DMS-100, same problem with two
different telcos.

-Phil
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>