(ASCEND) RE: max4k dialout radius profile

[Daniel <daniel@lynx.bc.ca>]

Hi there,

We have a client that we have setup so that our Max4k will initate a call
to the client's router (p50/p75) when it is needed (eg. mail, web request).
To bring up one channel is not a problem. The profile is shown below.
However, we need to establish two channels when we call the client's site.
That means, two dialout number to be in the radius profile. Can I put two
number in the "Ascend-Dial-Number" ? If yes, what should be the right
syntax? If no, any way to accomplish this?

Regards,

Daniel


client-out        Password ="ascend", User-Service = Dialout-Framed-User
        User-Name = "username",
        User-Service = Framed-User,
        Framed-Protocol = MPP,
        Ascend-Dial-Number = "1234567",
        Ascend-Send-Auth = Send-Auth-PAP,
        Ascend-Send-Passwd ="passwd",
        Framed-Address = 123.123.123.123,
        Framed-Netmask = 255.255.255.224,
        Ascend-Data-Svc = Switched-64K,
        Ascend-Base-Channel-Count = 2,
        Ascend-Maximum-Channels = 2,
        Ascend-Idle-Limit = 60    
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>