Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Problems with DBA on a Pipe75
At 12:15 PM 9/17/98 , Josh Tiefenbach wrote:
>I'm experiencing some problems using DBA/MP+ on my Pipe75.
>
>According to the documentation for rev 6.0 of the software, if a pipe has 2
>data calls initiated to the same number, and an incoming voice call is
>detected, then one of the data calls is dropped, and the voice call is routed
>to the POTS jack.
>
>Problem is, it dont work that way for me.
>
>If I have both channels up with data calls (and they are to the same number)
>and try dialing one of my SPIDs (either one), then I get a busy signal.
>
>Various relevant bits of info:
>
>Old style (slide switch) Pipe75: b.p75 load
>6.0.2 of the software.
>Switch Type: NTI
>Phone 1 Usage = B
>Phone 2 Usage = B
>Phone Num Binding = No
>
>Any suggestions?
Have your telco *confirm* that your line is configured per the instructions
at:
http://www.ascend.com/1601.html
most likely omission is "ACO" based on your problems.
Kevin Smith (kevin@ascend.com)
Ascend Communications...
...where Network Solutions never end.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: