Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) NAT kills throughput?
At 04:10 PM 5/15/98 -0400, Phillip Vandry wrote:
>Has anyone else experienced the following problem?
>
>P50's or P75's running 6.0.2 and Single IP NAT.
That's exactly my setup.
>Workstations behind the Pipeline cannot pull more than 4K/s through
>the Pipeline instead of the 8K/s you'd expect out of one channel or
>16K/s out of 2 channels. This problem is consistent.
I'll check it.....xfer rate was 12.2 KB per second. I have Link Comp
enabled....it was xferring an Ascend binary image. Both channels were
up for the duration, and the session had been established about 4
minutes. I'll try again over the weekend at different times, after
differing session lengths and different file characteristics to see
if I get much difference.
>Turning off NAT enables data to be transfered at full throttle.
I'll have to do some reconfiguration at the office to do the
comparisons...
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: