-- BEGIN included message
- To: rddirkse@pi.net
- Subject: Re: (ASCEND) factory state
- From: Rob Dirksen <rddirkse@pi.net>
- Date: Sun, 01 Mar 1998 13:51:11 +0100
- Organization: Planet Internet
- Posted-Date: Sun, 1 Mar 1998 14:27:46 +0100 (MET)
- References: <34F80921.6F27@pi.net>
- Reply-To: rddirkse@pi.net
Altough it might be strange to reply on my own questions I do in anyhow. FYI I found out that it is impossible to clear the nvram if you have not performed at least once since the birth of your box an fsave. After I had fsaved a config the commands fclear and nvramclear performed ok. Rob Rob Dirksen wrote: > > Hi all, > > I seem not to be able to get a p50 5.1A back in its factory state. > I go in diagnostics mode and do > fclear > the unit returns > . > > I do a > . >nvramclear > the unit resets and is still in the same config state as before. > > any ideas ? > > ++ Ascend Users Mailing List ++ > To unsubscribe: send unsubscribe to ascend-users-request@bungi.com > To get FAQ'd: <http://www.nealis.net/ascend/faq> ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <http://www.nealis.net/ascend/faq>
-- END included message