Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) v.90 & NFAS on 4004
At 06:55 AM 7/8/98 -0500, you wrote:
>At 04:29 PM 7/6/98 -0500, Marcel Brown wrote:
>>>The guy "doing it right" is simply not accepting digital (ISDN) calls using
>>>MPP. That is the cause of the IP address pool leak.
>>
>>I've been running 6.1.3 for over a week now and I accept ISDN calls, as
>>well as analog, using multi-link PPP. So far, so good. No IP pool leaks.
>
>Actually I think the secret here is that you *are* allowing MP calls. Those
>that are not, and get *failed* attempts as a result seem to be getting the
>pool leak most prevalently.
So what should I say "no" to?? In Allowed... I went back to 5.03 something
version yesterday, lacking a fix for the IP Pool Leak problem with 6.1.3
... No Leaks - but did of course loose V.90 support.
PS: On another Problem with a Max 4004... Telco set up the 3 Pri's going
into it as the following.
1st PRI Span from TelCo setup as 'seperate' NFAS group, so I have had to
plug it in as if it were my 3rd Span on the unit, with it's own D Channel
and NFAS ID = 1 (with Ch 24 set for NFAS-Second)
The other PRI's from the Telco (Span 2 and 3), I plugged into the Max as my
Span 1 and Span2.. The Telco said this is how they were designed (as one
group). The 1st of those 2 has a Dchannel the second of those two spans
doesn't have a D Channel - All B's. Anyway, those I setup as NFAS ID NUM =
0 on the first Span, and NFAS ID=2 (no D channel) for the second Span.
1st Span has Ch 24 set for NFAS-Primary
All looks good on the 10-100, 10-200, 20-100 Terminal Screens, but Calls
get "answered" then immediately dropped... TelCo still thinks it has
something to do with 'too much slip' which I previously fixed on another
unit by changing timing source for all Spans to NO except for the 1st Span
of the group.
Thanks.
***** Top Net InterNet Services *****
Omaha, Nebraska Husker Heaven
www.top.net (402) 291-1542
Visit Our BBS at: www.hawgwild.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>