Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) 2.1.9 for MaxTNT
TAOS Release 2.1.9 for MAX TNT and DSL TNT has been given to customer
support and to manufacturing. This release contains the following:
Corrections:
* TR 2119 User could not open a session with a card following an
abnormal disconnect.
* TR 3222 D-channel flapping on idle channelized T3 card.
* TR 3280 RADIUS accounting logged CLID and DNIS information improperly.
* TR 3281 IP pool leak on multichannel PPP calls.
* TR 3310 Acct-Reset-Time and Auth-Reset-Time sometimes did not work.
* TR 3317 T1 Frameline card could fail to initialize ports.
* TR 3358 Backup profile for Frame Relay connection did not work properly.
* TR 3384 MAX TNT could send non-stop authentication requests if RADIUS
did not respond.
* TR 3427 MAX TNTaccepts any date from 0-31, month 0-12.
* TR 3457 Slot card reset when SNMP deactivated a Frame Relay PVC.
* TR 3517 Loadslave command could bring down a slave shelf with FE1.
* TR 3706 TS-Idle-Timer did not work properly for Telnet sessions.
* TR 250211 Link Up/Down traps were not generated for SWAN lines.
* TR 258578 Some asynchronous PPP dial-ins over ISDN failed to connect.
* TR 1000064 Adding MP channels on multiple HDLC cards could bring down
an HDLC card.
* RADIUS Stop packets reported Ascend-Data-Rate as zero for ISDN calls.
* NasPort and NasPortType now reported in pseudo-user RADIUS requests.
* Session time difference between RADIUS and system fixed.
* Invalid Frame-Relay profiles were created following client requests.
* Fixes to SNMP WAN traps.
* DNIS-authenticated calls were not handled properly with DNIS-Preferred.
* SNMP reported ssnStatusCurrentService as Unknown(0) .
* RIP-Use-Multicast caused system to reject RIP-v2 broadcasts.
* In some cases, OSPF routes could point to an incorrect next hop.
* IP pool leak could occur when pool ranges were contiguous.
* MAX TNT did not broadcast RIP on WAN with RADIUS Framed-Routing.
* Fragmented UDP and TCP packets could be forwarded incorrectly.
* FR-Direct incoming call was accepted without checking DLCI state.
* MAX TNT did not recognize a valid ISDN Information Element.
* HDLC card could FE104 or FE40 under heavy load.
* HDLC cards could generate FE8 after continuous load of multilink calls.
* IP pool leak occurred when running IP over ARA with Defender.
Enhancements:
Enhanced Uptime command
Immediate login after changing expired password
RADIUS Filter-ID
Authentication failure Reply-Message sent to client
ADSL-CAP modem rate control for CPE sessions
Backup interfaces
Access to the global routing table from RADIUS private routes
Partial support for the ATM MIB (RFC 1695)
HDLC channels displayed with different numbers
Rockwell code version:
V.90: V2.084-K56_2M_DLP_CSM
Matt Holdrege http://www.ascend.com matt@ascend.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>