Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) IP Pool leak in 6.1.3
Hi,
Yes, it seems to be a well-known although not well identified problem...
Have a look at the Reset Equipment set command in the SNMP MIB... Ooops,
still not present ! Well, no way, you have to restart the equipment :-(
Paul
Dans son message (In his/her message), Bob Dozier ecrivait (wrote) :
> Has anyone experienced an IP pool leak problem on Maxen
> 4000's and 4048's with 6.1.3? I upgraded to 6.1.3 this AM
> and in less than 6 hours later, there is no IP available from
> the pool when the 2 PRI's have lines available.
>
> I have been running 5.0Ap16 for a LONG time
> with very good stability and then WHAM! with 6.1.3.
> Any suggestions? I am limping by with the pool range/count
> set to 80 instead of 48 as before.
>
> ...Bob
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
Paul Rolland, rol@oleane.net
OLEANE SA/Service Technique/Directeur Technique Adjoint
OLEANE SA/Technical Service/Deputy Technical Manager
--
Support technique et operationnel Oleane : support@oleane.net
Test du mail : ping@oleane.net
Please no MIME, I don't read it - Pas de MIME, je ne le lis pas
Please no HTML, I'm not a navigator - Pas d'HTML, je ne suis pas un navigateur
"If you're not scared, you don't understand" - Mike O'Dell, VP UUNet Tech. Inc.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: