Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) RADIUS: radif on TNT vs 4048
Joe Pautler wrote:
]
]we have recently installed (2) tnt's to add to our two 4048's.
]i have noticed that the "radif" diagnostic command seems to
]work drastically different. on the 4048's i can see the queries
]being sent to the radius servers, and i can see the reply coming
]back containing all of the attributes, etc. however when i turn on
]radif on the tnt's i can authenticate with the tnt without ever
]seeing a single radif message....although i do see some radif messages
]every once and a while...but not nearly as verbose as with the 4048's.
]i know that i am authenticating via radius because i can watch
]it happen via tcpdump (unix sniffer). the tnt's shipped with 2.0.7 and
]i saw this behavior. i have since upgraded them to 2.1.3 and they
]still act the same. can anyone give me any input on this? thanks!
and the answer is... you have to have a session opened with the
specific card/slot (modem, hdlc, etc) that is causing the
radius traffic, *and* you must enable debugging. such as:
TNT200-79 <Manager> open 2 7
mdm56k-2/7> debug on
Diagnostic output enabled
mdm56k-2/7> radif
RADIF debug display is ON
___________________________________________________________________________
Joe Pautler, E.I.T. University at Buffalo
CIT/OSS Network Engineering 224 Computing Center
http://www.oss.buffalo.edu/~pautler (716) 645-3536
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: