The auth portion of Merit v2.4.23C works *great* .. it's the accounting portion that's been a pain in the ass, so far. Mind you, the Max has always done this: send far too many Start/Stop packets for absolutely no reason. Is there some reasoning behind this? It's entirely possible I don't have it set up properly; I basically used the defaults that the Max was set for. Any hints at this point would be nice.. even under Ascend's radius, it still spits out tons of stop records for no reason. Clues? -- Gilles Melanson - ViaNet Internet Solutions System/Network Admin - 128 Larch St., Sudbury, ON, Can P3E 5J8 gilles@vianet.on.ca - Phone#: (705) 675-0400 ICQ UIN: 1944562 ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <HR> <STRONG>Follow-Ups</STRONG>: <UL> <LI><STRONG><A HREF="msg09134.html">Re: (ASCEND) Merit radius and Ascend .. hints?</A></STRONG></LI> <UL> <LI><EM>From</EM>: Josh Bailey <joshb@xtra.co.nz></LI> </UL> </UL> <!--X-Follow-Ups-End--> <!--X-References--> <STRONG>References</STRONG>: <UL> <LI><STRONG><A HREF="msg09122.html">Re: (ASCEND) Merit radius and Ascend .. hints?</A></STRONG></LI> <UL> <LI><EM>From</EM>: Josh Bailey <joshb@xtra.co.nz></LI> </UL> </UL> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg09125.html">Re: (ASCEND) Can a p130 handle a full t1?</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg09123.html">Re: (ASCEND) Kerberos / NT's Auth. and MAX</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg09122.html">Re: (ASCEND) Merit radius and Ascend .. hints?</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg09134.html">Re: (ASCEND) Merit radius and Ascend .. hints?</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#09124"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd179.html#09124"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>