On 9/8/97 4:28 PM, Kevin Smith scribbled: >Maybe Matt already did this, but for redundancy: > >5.1A for the Pipelines has been given to manufacturing and support. This >release includes the following new features and corrections: > >New Features: >* Pipeline can act as an ATMP Home Agent >* Support for increased number of default IPX SAP proxy servers >* IPX filters >* Support for IPX without defining an IPX server >* Changes to the IP router >* New Answer profile option for dial-in NetWare clients >* Pipelines can accept Data Over Voice (DOV) calls >* Configuration with a touch-tone telephone >* AppleTalk routing added >* Caller ID supported on newer Pipeline 75 analog ports >* Error checking for channel ranges in the Pipeline 130 >* Set system clock through SNMP >* Local DNS host address table option added >* SNMP can detect concurrent sessions >* X.25 T3POS support >* Pipeline now checks for maximum number of DS0s >* Removing routes to a host when the connection is down >* SNMP system reset >* SNMP can obtain active call status >* SNMP can monitor WAN lines and channels >* New X.25 user facilities parameters added >* User-configurable call blocking after failed connection attempt >* SPX spoofing added for IPX >* Firewall Control Protocol managed by SNMP >* DNIS support for TCP-CLEAR, X25/PAD, and X25/T3POS calls >* Network Address Translation using a single IP address >* X.29 Reselection PAD message support >* X.25 over the D channel >* Maximum number of ATMP Tunnel sessions can be set >* DHCP services enhanced >* IDSL voice call support >* SNMP Traps for BRI linkUp and linkDown >* Manual T1 loopback using the line transceiver >* Add basic IP Security functionality to the router >* SNMP request authentication added >* Dial-in PPP support for AppleTalk >* Supporting Secure Access Firewall Enhancements >* NAT for LAN feature allows IP addresses below 100.100.100.100 >* Configure port for Syslog messages >* Spoof Adr parameter allows any subnet address and mask >* SNMP write security disabled by default >* TFTP checks for compatibility of downloaded files >* Three alternate numbers added to P130 connection profiles >* Accessing the PAD on the Pipeline 75 >* IP-only software load for the Pipeline 130 >* Network Address Translation (NAT) for a LAN >* RIP-v2 can use Multicast IP and MAC addresses > >Corrections: >TR Description >----------------------------------------------------------------------------- >1247 Discard Profile Name was used on 1st dial-out. >1559 IPXCP connect failed between 3Com Office Connect 510S & P50. >1621 P75 and P130 - 2 channel MPP over voice did not work. >1633 P25 and P75 - Unsupervised calls would disconnect. >1687 P130 starting channel above ending channel caused fatal error. >1709 P130 Dial back up did not negotiate a 2 channel call. >1848 P130 using Frame Relay, ISDN backup not triggered by IPX traffic. >2015 P130: UBRI L56 Nailed group changed to 3 after tloadcode. >2012 Using NAT, call filters were not applied. >2064 P130 lost its configuration when doing a fsave, nvramclear. >2010 P130 loses partial configuration after upgrade. >2009 P130 stopped trying to establish its T1 link after 128 attempts. >1894 Pipeline 75 inappropriately answers call. >1690 The show fr dlci command gave incorrect (negative) results. >2086 P50 SAP table not fully propagated across nailed 56K link on startup. >2562 Pipelines do not have the 224.0.0.9 multicast option for RIP-v2 >2573 Listen command is unavailable in X.25PAD >2065 Not sending IPX RIP/SAP to a Cisco 2503 >2460 P75 delivers alternating tone on POTS after call is terminated. >1253 P25-2 chan data call up. Incoming call is answered but put on hold. > >-- Patti > > > > >Kevin > > >++ Ascend Users Mailing List ++ >To unsubscribe: send unsubscribe to ascend-users-request@bungi.com >To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> > -- Mark Eissler | Interlog Network Operations Group meiss@interlog.net | 24hrs/7days (416) 920-2655 x2266 (416) 920-2655 x2219 | dedicated@staff.office.interlog.com Interlog Internet Services <A HREF="http://www.interlog.com">http://www.interlog.com</A> <----------- Please quote original message with reply. ----------> ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg08462.html">Re: (ASCEND) Ascend Patch 5.0ap23?</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg08461.html">Re: (ASCEND) MAX 4000 + 56K modem cards = fire</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg08684.html">Re: (ASCEND) 5.1A for the Pipelines</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg08449.html">(ASCEND) K56flex client downloads</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail17.html#08463"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd156.html#08463"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>