iso(1).org(3).dod(6).internet(1).private(4).enterprises(1).
ascend(529).systemStatusGroup(9).sysReset(8)
Nothing happens though - my SNMP program (SNMPc) just kicks
back to the higher level hierarchy. When I try to do an
explict set it reports an error saying the write was
refused. I know for sure the read/write community is
set right because I used the same settings to save
my config via TFTP and to upgrade the MAXes firmware (all
via SNMP)
Anybody have any advice? Thanks in advance.
PS - Many thanks to Jason Nealis and his FAQ on using
SNMP to save/restore/upgrade MAXen. I've gotten to the
point where I have too many MAX boxes to telnet to them
to upgrade. If I can figure out this remote reboot thing
I'll be all set!
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>>
</PRE>
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<HR>
<STRONG>Follow-Ups</STRONG>:
<UL>
<LI><STRONG><A HREF="msg08415.html">Re: (ASCEND) remote reboot of MAX via SNMP</A></STRONG></LI>
<UL>
<LI><EM>From</EM>: Scott Kozicki <SKozicki@BlueStar.net></LI>
</UL>
</UL>
<!--X-Follow-Ups-End-->
<!--X-References-->
<!--X-References-End-->
<!--X-BotPNI-->
<HR>
<UL>
<LI>Prev by Date:
<STRONG><A HREF="msg08408.html">(ASCEND) Confused re: software options for Max2012/2024/4046</A></STRONG>
</LI>
<LI>Next by Date:
<STRONG><A HREF="msg08406.html">Re: (ASCEND) K56 Card Upgrade</A></STRONG>
</LI>
<LI>Prev by thread:
<STRONG><A HREF="msg08402.html">(ASCEND) Crawling Connects</A></STRONG>
</LI>
<LI>Next by thread:
<STRONG><A HREF="msg08415.html">Re: (ASCEND) remote reboot of MAX via SNMP</A></STRONG>
</LI>
<LI>Index(es):
<UL>
<LI><A HREF="mail20.html#08407"><STRONG>Main</STRONG></A></LI>
<LI><A HREF="thrd153.html#08407"><STRONG>Thread</STRONG></A></LI>
</UL>
</LI>
</UL>
<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</BODY>
</HTML>