There is not an exact equivalent. 'debug' is activated by toggling one of the debug commands. If you type a question mark, you'll see commands tagged as "debug" eg : admin> ? ? ( user ) @fatalTest ( debug ) acctevnt ( debug ) addrpool ( debug ) arptable ( system ) atmpdebug ( debug ) once you've toggled 'on' the debug command of choice, you must turn on the switch that causes the output to be displayed to your screen : eg : admin> debug on Diagnostic output enabled admin> admin> debug off Diagnostic output disabled admin> Further - your administrative user profile must have debug enabled. For example, if I want 'admin' to be able to use debug : admin> admin> read user admin USER/admin read admin> set allow-debug =yes admin> write USER/admin written admin> Note that if you list a user profile that doesn't have 'allow-debug' set to yes, this parameter will not show up in the 'list' Dave. > >Regards >-- > Atentamente. > > >*************************************************************************** **** >Enrique Josue Torres Angeles eta@rcp.net.pe >Dept. de Proyectos Lima - Peru >Dept. de Operaciones >Red Cientifica Peruana Telefono : 51-1-9544799 >Av. Larco 770 - Miraflores 51-1-2415689 > 3er Piso Fax : 51-1-2411320 >*************************************************************************** **** >++ Ascend Users Mailing List ++ >To unsubscribe: send unsubscribe to ascend-users-request@bungi.com >To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> > -- David Howard Escalation Support Ascend Communications Service & Support dhoward@ascend.com <A HREF="http://www.ascend.com/service">http://www.ascend.com/service</A> ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg08314.html">Re: (ASCEND) MAX4000: no trunk available</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg08312.html">Re: (ASCEND) MAX 2012 and ISDN...</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg08318.html">Re: (ASCEND) Debug mode on MAX TNT</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg08321.html">(ASCEND) Re: Max 200+ and BRI hunt groups (SUMMARY)</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail23.html#08316"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd149.html#08316"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>