> > Yes, To do this you need to go Full Access and then you have to go into > TermServ, CNTRL-D---> TERMSERV > > ascend% open 3:1 > > Connected to modem 3:1... > > ati3 > V1.054_NOTNT-K56_DLP_CSM > > You must have Modem Dialout=Yes in the TermServ Config. On a slightly different note, does the reporting of busy signals work properly for anyone when dialing out from a max? On a box running 5.0Ai13 (but it has been happing for a long time, since 4.6something), attempting to dial out to a number that is busy results in no response until it times out 30 or 60 seconds later and gives a NO CARRIER. Note that the max logs a "sys use exceeded" almost immediately. This is on a 40004, 2 PRIs, switch type NTI, happened both with DM12s and 12 modem 56k cards. We reported this as a bug to Ascend a long time ago, but they just said "hmm, interesting" and we didn't really get any response. Checking archives, we first noted and reported it in 4.6Cp11. ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <HR> <STRONG>References</STRONG>: <UL> <LI><STRONG><A HREF="msg08266.html">Re: (ASCEND) Rockwell Firmware version</A></STRONG></LI> <UL> <LI><EM>From</EM>: Jason Nealis <nealis@babylon.erols.com></LI> </UL> </UL> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg08287.html">(ASCEND) Re: Re: OSPF question</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg08286.html">Re: (ASCEND) Supra 33.6 and Max4000</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg08271.html">Re: (ASCEND) Rockwell Firmware version</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg08274.html">Re: (ASCEND) Rockwell Firmware version</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail25.html#08284"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd147.html#08284"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>