Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Modem Outdial Works ! (was: Re: (ASCEND) MaxDial / K56flex)
Re^2,
On Mon, Sep 29, 1997 at 12:37:14PM +0200, Andre Beck wrote:
> On Sat, Sep 27, 1997 at 05:40:57PM +0700, Joseph Bridgewater wrote:
> > Andre,
> >
> > Bad news for you (j/k): I'm using K56Flex with 5.0Ap27 and outdial works
> > fine!
>
> Actually this is good news for me ;)
>
> > But they still seem to have a bug where a Route IP=Yes /
> > Call Type=Perm/Switched / Data Svc=Modem connection profile can NOT outdial
> > when global Bridging=No.
>
> There is even an image "ebok.m40" available which would mean they really
> finally got it. Was about time ;)
It wasn't all that nice because the same failure as with all versions
before popped up: It dialed nonsense numbers or nothing at all. However,
now knowing that it must work, we dived a bit into the debug mode and AT
commands, and finally found it: It's an A-Law vs. u-Law issue ! Thus no
American would ever notice the problem...
All problems suddenly disappear if you send the modulation selection code:
at+ms=56,1,300,33600,1,0
^
This sets A-Law for us Europeans, and after that, dialing works like a charm.
Seems that the Ascend decodes the DTMF the chips send upstream to him, and
with the wrong x-Law, this fails badly.
The bad thing actually is that users have to find this out...
--
Kanther-Line: PGP SSH IDEA MD5 GOST RIPE-MD160 3DES RSA FEAL32 RC4
+-o-+--------------------------------------------------------+-o-+
| o | \\\- Brain Inside -/// | o |
| o | ^^^^^^^^^^^^^^ | o |
| o | Andre' Beck (ABPSoft) beck@ibh-dd.de XLink PoP Dresden | o |
+-o-+--------------------------------------------------------+-o-+
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: