Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Dedicated T1 Serial Wan profile
We have used this successfully, between a M4k and a Bay - it worked just
fine. From memory there were no special tricks required on the MAX side
(apart from using PPP encapsulation, but that was for compatibility with the
Bay - anyway you are getting the link up (as in "LAN session up"?) so
that must be ok).
You aren't using 4.6B s/w by any chance? That's the one that escaped
with the dreaded idle timer zero=zero bug - after zero seconds of
idleness it dropped the PPP link, roughly the symptoms you describe.
Regards,
Neale.
On Sun, 17 Aug 1997, Marc Newman wrote:
> Anyone have any advice for someone who is trying to get a dedicated line going
> between two Maxes with the serial WAN port and an external CSU/DSU? I have it
> set to Group 64, and set up the profile for Nailed, and I have seen the
> connection come up, but it goes down almost immediately. I have gotten one
> ping across the link. That's it.
>
> Marc
-----------------------------------------------------------------
Neale Banks Ph: +61 3 9205 0333
Network Manager Fx: +61 3 9819 0533
Planet Internet & Integration Design
neale@idesign.com.au neale@planet.net.au
http://www.idesign.com.au http://www.planet.net.au/
-----------------------------------------------------------------
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: